Support |
> >>This problem seems to go away after reinitializing on >>boot up but its not holding my settings in memory. > >So the next time you switch it on (without holding Param), its crashing >again? >>>>>>Yes until its re initialized. >>Is this hardware > >Probably the EEPROM (non volatile memory) > >>these little gremlins be swept away by installing Loop5.0? > >I doubt it. >>>>>>>Wonder if I could get Oberheim to send new EEPROM( without sending >>>>>>>unit into oblivion)Unit is still very much under warranty. >>Also the beat sync input does not function on my Echoplex > >Maybe you did not quite understand its function. >Does the Plex's green dot between the two multiple digits flash when its >in >Reset and receives sync pulses? >If it does, the next Record will be quantized to fit into the puls pattern >it receives. From then on it will stay synced, confirming with the same >green dot whenever it corrects time. >>>>I was attempting to use it for stuttering effects as outlined in the >>>>manual & discussed recently on this list.I have tried using a >>>>footswitch & several audio sources with sync "In"enabled I also >>>>disconected midi but no action. On the subject : Is the upgrade available from Oberheim- Nashville now? Matthias thanks for your reply. K Law