Re: Echoplex cycle question

[Bret <echoplex@yahoo.com>]

David,
I can't check this because I am away from an edp, but check your
switchquant setting.  

I believe a given loop will always begin where it was last left
playing.

So if switchquant = on, it will go to the nextloop (say loop 2) at the
end of a loop boundary (the end of loop 1).  Thus, when you come back
to loop 2, it will be at the beginning of that loop (loop 2, since you
left loop 1 at the end of that loop).  

If you have switchquant = off, then you are able to go from loop 1 to
loop 2 ANYWHERE inside loop 1, thus when you return to loop 1 you are
at WHATEVER point you left loop 1 to go to loop 2.

If what I say is correct, you want to set switchquant = on.

Again, this is from memory, I can't check it with an edp right now.

bret
--- david auker <davauk@hevanet.com> wrote:
> Hi,
> 
> I've a Gibson Echoplex set up for 6 loops.  When going to the "Next
> Loop" it seems I arrive at the cycle that was upcoming last time
> there. 
> Is there any way to always arrive at the 1st cycle, in other words,
> the
> beginning of the loop? 
> 
> David
> 


__________________________________________________
Do You Yahoo!?
Get Yahoo! Mail - Free email you can access from anywhere!
http://mail.yahoo.com/