Support
Looper's Delight
|
Support |
|
|
At 11:53 AM 5/15/01 -0700, Mike Biffle wrote: >Hi Dan... I'm with you on this issue. I found the PMC-10 midi controller's delay time unacceptable as well. I'd go with hard wired footswitches. I used to controll feedback and other functions with midi as well, but tap just didn't cut it. i don't think it's an issue with the pmc-10, or with midi for that matter. i use a modified peavey pc1600/rolls rfx midibuddy combo to control an edp record function using midi without similar problems. the peavey to jamman/edp midi chains are exactly the same to the point where parallel midi outputs feed both, and the jamman is just not as quick to respond to midi tap as the edp is to midi record. At 12:43 PM 5/15/01 -0700, rich wrote: >really? are you synched to a midi clock? or are you just looping >freeform? >if it's the latter...hmmm...i haven't seen any delay using my midi >pedal. you must be doing some very critical stuff! this is freeform. it shows up when trying to start a loop with input having a sharp transient attack, which gets cut off on the jamman when i'm using midi tap. i suppose it's possible you could get used to tapping just a bit ahead of the downbeat in this case, though that wasn't easy or natural when i tried it. i'd rather just use a hardwired footswitch and not have to adjust my timing based on which box i'm using. ___ dan mcmullen, ca, usa don't worry - pay attention mailto:dog@well.com 707-485-0220 pgp fingerprint = 1C70 8D81 6B94 93A9 F2D8 9609 2122 BF70 8619 EDAF