Looper's Delight Archive Top (Search)
Date Index
Thread Index
Author Index
Looper's Delight Home
Mailing List Info
[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

RE: PMC10 problem

Steve,

The only other thing I can think of is to change the battery inside the
footpedal that stores the memory.  It is a 4.5 volt battery a little bigger
than a AA size.  I was having some memory corruption issues and changing
the battery fixed everything.


Ed


>Hi Ed,
>
>Well my original configuration had the PMC10 set on channels 15 & 16.
>After it went through its initial reset, it would no longer communicate
>so I had to use the handheld controller to change the midi channels back
>to what I had originally programmed.  I then tried the upload again and
>the PMC10 was able to respond to the data, but ultimately ended up like
>before doing a full reset back to factory defaults.  It is almost as if
>it gets all the data and then locks up (with all lights on) providing a
>reset (to default) as the only option to get the unit working again.
>
>Steve
>
>
>>
>> Steve,
>>
>> I ran into this recently. It might be because because in the
>> factory reset state NONE is the channel selected for the PMC
>> 10.  On page 3-11 of my PMC 10 Owner's Manual it says "The
>> PMC10 will only transmit and receive PMC10 SysEx data when
>> PMC10 Channel is 1-16." Go to submenu of MIDI and set PMC
>> Channel to 1-16.  Hopefully that's all that it is.
>>
>> Ed
>>
>>
>> >
>> >Hi Sean (or any LD PMC10 owner),
>> >
>> >
>> >I performed a download of my PMC10 using Raymond and then saved the
>> >file on my PC.  Everything seemed like it was working just
>> fine.  Then
>> >for some reason, I accidently did an upload of the current saved
>> >document, however the PMC10 reacted by flashing its display
>> erratcially
>> >and then ending with a message in the display stating to
>> press enter to
>> >reset.  Low and behold, the system was reset back to factory
>> defaults
>> >and now I can't seem to restore the saved document that I
>> created using
>> >Raymond.  Any ideas would be very helpful  & I would rather
>> not have to
>> >manually set everything back up (82 patches, 12 banks,
>> etc.).  My midi
>> >connections appear to be working properly, just for some reason when
>> >Raymond says that it is transferring data, the PMC10 doesn't
>> seem to be
>> >putting it where it needs to be.
>> >
>> >
>> >Thanks,
>> >Steve
>> >
>> >
>>
>>
>>
>>