Re: Vortex Repair

[SoundFNR@aol.com]

> I ordered a replacement pot for the parameters on my Vortex- I tried to
>  replace one before without success- I'm decent with soldering skills but
>  this was difficult- it looked perfect but was not working- I'd like to 
>try
>  it again on this new one- any suggestions or tips for the procedure
>  appreciated.

Remember its a double sided circuit board, so you need to solder from both 
sides.

Check for breaks in cicuit board tracks, particularly any that might have 
been caused  by removing the old pot.

andy butler