Looper's Delight Archive Top (Search)
Date Index
Thread Index
Author Index
Looper's Delight Home
Mailing List Info
[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: Copying presets with FCB 1010 (was Re: Behringer/Repeater(EDP) foot controller)

many thanks for this!

best,

rich



>  >
>>  Sure! You can also use one of the two cc pedals to work the repeater
>>  feedback (as an expression pedal). IMHO the FCB1010 turnes out to be a
>quite
>>  open system. But it's hard to understand the manual and programming 
>takes
>a
>>  lot of time. There is no way to copy a bank, so for each new bank you 
>have
>>  to redo everything from scratch.
>>
>
>(Snipped from: http://www.altrion.org/fcb1010 )
>Behringer FCB1010 Extra HOWTO
>These are in an addendum to the manual published on Behringer's site in
>January 2002: thanks to Jos van Hoorn for drawing it to my attention. The
>text is taken from the (with minor editing).
>Copying Presets
>Activate CONFIG in the GLOBAL SETUP (see chapter 2.2 of the manual). Now,
>press footswitch 5 to activate the copy function. (The VALUE 1 LED lights 
>up
>and the number in the display starts flashing.) Enter the number of the
>preset you wish to copy and confirm your selection with UP/ENTER. Presets
>1 - 10 are stored in bank 0, presets 11 - 20 in bank 1, and so on. (The
>VALUE 2 LED lights up and the number in the display starts flashing.) 
>Enter
>the target preset and confirm your selection with UP/ENTER, or cancel with
>DOWN/ESCAPE. If you want to copy further presets, please press footswitch 
>5
>again. Press and hold DOWN/ESCAPE to quit the GLOBAL SETUP.
>Toggling between two controller values in a patch
>Allows you to configure one controller so that it alternately sends two
>different values, e.g. effect bypass, drive on/off, etc. In order to 
>enable
>the controller switch-over function, you need to globally select the same
>MIDI channel for CNT1 and CNT2 (see chapter 2.2), and enter the same
>controller number for CNT1 and CNT2 in the preset (NUMBER, see chapter
>2.3.2). The first time you recall the preset, it will send the controller
>value of CNT1 (VALUE 1), with each additional key press you can alternate
>between CNT2 and CNT1. Example: Select preset 1 without DRIVE function on
>the BEHRINGER V-AMP each time you press the same button again, DRIVE will 
>be
>switched on or off respectively: PROG CHG 1 = 1, CNT 1 NUMBER = 26, VALUE 
>1
>= 0, CNT 2 NUMBER = 26, VALUE 1 = 127.