A FIX! (was Re: Behringer FCB1010 HELP!)

[Mark Sottilaro <sine@zerocrossing.net>]

OK, I'm wrong!  The FCB1010 DOES in fact control the output level of the 
Repeater via CC (CC#110 controls channels 1&2, CC#111 3&4)

Why wasn't mine (or Michael LaMeyer's) working?

They were WAY out of calibration!  WAY OUT!  Poking around the web I 
came across this little nugget:

http://www.altrion.org/fcb1010/post.html

and followed a total calibration procedure.  Woop, there it is.  After 
following this simple procedure, my FCB1010 now works fine... for 
sending CC from the expression pedals.  Can't confirm whether the other 
issue about PC numbers not all working, but I also found a post 
somewhere that states the FCB1010 spits out a PC+1 message, which could 
be the source of many of the problems with this badboy.

On the upside, I've found that of all (MidiWizard and Yamaha) the MIDI 
controllers I've purchased, this one is by far the best for controlling 
the Repeater.  Also the cheapest.

Now, I just have to make EVEN more room on my floor to deal with it!  
YIPE!

Mark


On Sunday, March 17, 2002, at 11:20  AM, Hedewa7@aol.com wrote:

> sine@zerocrossing.net writes:
>
>> 'm sad about not being able to change output levels too, but it's not
>> the Behringer that's at fault.  It's the Repeater.
> did i miss something, here?
> i change track levels on the repeater, all the time, via midi.
> ???
> best,
> dt / s-c
>