Re: EDP Loop4 MIDI Reset?

[Claude Voit <c.voit@vtx.ch>]

Hans

1st, if you have a pc get yourself Raymond the pmc10 editor for windows
at
our LD member Sean's site
http://www.mindspring.com/~sean_/pmc/index.html
it will be much more simpler from there in the same download is a
Midi/hex calculator wich will help you master the hex/midi stuff

for those resets, a note on, on a momentary switch is enough if you want
to put the note off it is ok too
90 3d 7f : midi chan 1, midi note 61, note on (velocity 127)  

claude

Hans Lindauer wrote:
> 
> I wrote:
> 
> > > I spent a few hours over the weekend trying to figure out how to
> > program
> > > my PMC-10 as a controller for my newly-upgraded EDP.  I managed to
> > get
> > > record and overdub happening, but I tried to program a reset and
> > didn't
> > > have any luck.  Has anyone gotten this working yet?
> 
> Claude Responded:
> 
> > This indeed works enter 9x 3d 7f (x is you midi channel in hex)
> > use a momentary pedal type on the pmc
> >
> > reset only resets the current loop see it as a long record press
> > if you have multiple loops try general reset to reset all the loops
> > (9x 3e 7f)
> > or if you tweaked params you could also use pg ch 16 wich means reload
> > (the stored preset replaces the edited preset)
> 
> Now I see the difference between Reset and General Reset (another
> question I had).  I'm using the umbilical programmer to program the
> PMC-10 so I'm not familiar with those hex strings, but I'm guessing that
> the first hex value indicates the MIDI channel, the second is the note
> value, and the third is the velocity?  I left the velocity at 64 when I
> tried it - would that make a difference?  Also, should this be
> programmed as a note on/note off combination, or just as a note on?
> 
> Thanks Claude!
> 
> -Hans Lindauer