Support
Looper's Delight
|
Support |
|
|
|
Hi Bradley,
Try this. Set AutoRecord to ON. Now,
when you say NextLoop it does not go to the empty loop because the loop has not
been recorded yet. But if you have AutoRecord ON and the other settings as
described, if the next loop is empty it will go into record at the end of the
current loop. You can get an electronic copy of the EDP manual at the
Loopers Delight site at:
Good luck!
I am having a different problem with my EDP.
I have LoopCopy OFF, AutoRecord ON and SwitchQuant CYC. I record
loop #1. Then I press NextLoop and record loop #2, but I fluff
it. In order to recover I do a long press on Record, which clears loop
#2. But when I record loop #2 again there is a gap of silence at the
end. I think what is going on is that the length of loop #2 is not getting
erased, and I am playing slightly faster the second time I record. When I
end the recording it is not ending the loop at that point, but instead at the
original later end point. If I do a long press on Record followed by a
long press on Multiply (which clears all loops) I do not have this problem, but
I lose loop #1. Is this ringing any bells for anyone?
-Vance
|