FCB1010 Calibration

["Clifford Novey" <om@Om-Studios.com>]

Thanks Andy- I actually did this last night- found an unofficial 1010 page
with instructions- and I did notice that sometimes the lower value may stop
at 1 (amazing how much volume the EDP emits at 1) so I tried what you
suggested using less than the full range during calibration- Thanks again-

Cliff

----- Original Message -----
From: <SoundFNR@aol.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Tuesday, September 24, 2002 12:46 PM
Subject: Re: Loopers-Delight-d Digest V02 #623


> > Just got the FCB1010 and after assigning ExpA to Feedback control it
> >  only works over a very short range of the pedal- I tried reversing the
> >  Min and Max values to no avail- any ideas? Also- has anyone created a
> >  sysex dump of their FCB1010 to control EDP and/or Repeater they could
> >  send me? Thanks-
> >
>
> Hi Cliff
> a guy called Bruce had the exact same problem,
> Get you sorted in about 5mins. :-)
>
> andy
>
>
>
> OK Bruce, sounds like you're pedals need recalibrating.
> So here's the recalibration procedure, it's not on the Behringer site.
>
> I found it best to use "not quite" the full range of the pedal when
> calibrating, as following the instructions exactly
> can  give you a slightly reduced range.
>
>
> Behringer FCB1010 POST/recalibration HOWTO
> The original text is from Behringer support, posted to uk.music.guitar on
> 11th Dec 2001. I (Mike) have edited it a bit for clarity.
> Keep footswitches 1 and 3 pressed while switching on the unit (This bit
you
> can't do standing up!). Release the switches when the display blanks. The
> LEDs on the footswitches, the ones on the display and each segment of the
two
> numeric displays will turn on and off in sequence.
> Wait untill all footswitch LEDs are on. Depress all footswitches one at a
> time, including UP and DOWN, untill all LEDs are off.
> Wait untill relay switch test is finished. (There will be a couple of
> mechanical clicks, and the display will end up reading "F1" (at least, it
did
> on mine)). [Also, if you have connected a MIDI cable between the MIDI in
and
> out, the display will show "A1" before this, meaning the midi ports work
> correctly.]
> Press DOWN once.
> Adjust the left expression pedal (A) to the lowest value. Once adjusted
press
> UP.
> Adjust the left expression pedal (A) to the highest value. Once adjusted
> press UP.
> Adjust the right expression pedal (B) to the lowest value. Once adjusted
> press UP.
> Adjust the right expression pedal (B) to the highest value. Once adjusted
> press UP.
> Select a patch which has both pedals set to their full range, and check
the
> expression pedals now send 0-127 (0x00-0x7F)
>
>