Re: rolling your own

["Jonathan El-Bizri" <ssrndpty@hotmail.com>]

As usual, this list is a fountain of knowledge.

Thanks all. I'll do my best to pass on information when it's my turn.

Jon

----- Original Message ----- 
From: "Greg House" <ghunicycle@yahoo.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Thursday, May 08, 2003 3:41 PM
Subject: Re: rolling your own


> --- Jonathan El-Bizri <ssrndpty@hotmail.com> wrote:
>
> > Another question: As I mentioned, I need to combine multiple outputs
into an
> > input. So far, I've been doing this with female input y-cables, which I
have
> > read in more than one place, is a Really Bad Idea, since you are 
>feeding
the
> > line amp outs of each device into each other. Is this the case?
>
> It's really the impedence mismatch due to the outputs seeing each other.
here's a
> reference on how to rectify it.
>
> http://www.rane.com/note109.html
>
> > Is this a feasible solution? Wouldn't this affect the tone of the
signal?
>
> No.
>
> As far as parts go (from another msg where you asked...), I've had good
luck
> buying Neutrik & Switchcraft connectors from Markertek. Prices were 
>better
then
> other places I checked, and depending on how many you need, I believe you
can get
> quantity discounts. I believe their price on Canare wire was a bit lower
as well,
> but it's been awhile since I bought any.
>
> Greg
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
>
>