Support
Looper's Delight
|
Support |
|
|
--- THusken@aol.com wrote: > Hello everyone. > I just snagged an RDS 7.6 from an ebay auction. > Unfortunately the unit did not work when I received > it. The unit is in beautiful cosmetic shape and all > the led's are working, but the signal seems to 'pass > through the unit' without adding so much as a little > slapback. What gives? > This problem seems so drastic that to my untrained > brain, it seems like there might be a simple > solution lurking somewhere. > Any help you guys could give would be appreciated. > Thanks, Todd Husken Assuming the unit is not defective, you might try the following: 1) make sure the effect is engaged by pressing the effect button on the front panel 2) make sure you're connected to the mix and/or phase outputs & that the mix, input, & output knobs on front are turned up 3) make sure you're in delay mode & not sample 4) make sure that HOLD is not engaged You might even want to open the unit & adjust the trim-pot to see if this helps. Instructions for this procedure & the users manual are available on the LD website. http://www.loopers-delight.com/tools/timemachine/timemachine.html Good luck. I hope you didn't get a lemon. I bought one off ebay several years ago & although it's beat to hell, it still operates just fine. John ===== John Tidwell __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com