RE: 2 EDP in stereo: how to match parameters

["Glenn Poorman" <glenn.poorman@autodesk.com>]

If you're setup to use Brother Sync, any parameter selection
on the master should automatically be done on the slave as well.
When I setup my 2nd unit, I went through manually and set all
the parameters the same. After that, all parameter changes are
done with my MIDI foot controller and happen on both units.
Even if I were to change parameters on the front panel of the
master though, they would still change on the slave.

The one thing I haven't played with yet is presets. I'm finding
more and more reason to investigate this so I'll probably do
that within the next week.

Glenn

> -----Original Message-----
> From: JAMES FOWLER, III [mailto:jimfowler@prodigy.net] 
> Sent: Tuesday, February 03, 2004 1:51 PM
> To: Loopers-Delight@loopers-delight.com
> Subject: Re: 2 EDP in stereo: how to match parameters
> 
> sometimes i get glitchy behaviour, particularly when selecting
> the reverse function from the front panel on the master edp.  
> 
> of course, any control input into the slave edp will not be
> echoed to the master (midi connection is uni-directional).  
> 
> if i recall correctly (and there's a good chance i don't), you
> can connect them via midi and set the params on the master,
> which will in turn select them in the slave.  for example, if
> you're in param X and slave differs from master, then you can
> adjust slave to match and continue on with the programming.  
> 
> -jim