RE: 2 EDP in stereo: how to match parameters

["Neil Goldstein" <ngold@comcast.net>]

I hear you, I have already done this. I use 5 banks in my PMC set for one EDP and duplicated them for the second EDP.  

 

I was hoping to finess this using a few banks to control both, with a couple patches to switch from stereo to dual mono.

 

I think Sysex is what’s going to do this. A different ID # on each EDP

 

What is the sysex string that I’d need to put into the PMC to switch channels back and forth?

 

Say changing from Ch 6 to 7

Then changing back from 7 to 6

 

Neil

 

 

 

 

-----Original Message-----
From: JAMES FOWLER, III [mailto:jimfowler@prodigy.net]
Sent: Tuesday, February 03, 2004 3:37 PM
To: Loopers-Delight@loopers-delight.com
Subject: RE: 2 EDP in stereo: how to match parameters

 

"There's gotta be a simple workaround, that could change from dual mono to stereo via midi without touching the EDP."

there is...and it all has to do with the foot controller.  set each to a different channel, say 1 and 2.  program your controller to send identical messages on 1 and 2 simultaneously.  edp1 will accept ch. 1 messages and pass ch. 2 (i think...if not, split your midi cable to both units.)  this will allow for stereo operation.  do the same, but have the presets for edp1 and edp2 seperately.  now they should function fairly independently.

this is all just in my head though...never actually tried it, so it may not work.

-jim