Support
Looper's Delight
|
Support |
|
|
Claude I put these commands in my PMC10 after setting up the EDPs with the appropriate IDs, but am not getting any results. Is it possible to put a single sysex command to do this midi channel changing on the EDP? I understand you're wariness in helping a non-programmer, but I just want to do this ONE THING! Dedicated EDP "power-user" without programming chops... Thanks Neil > F0 00 01 30 0B 01 01 11 02 01 7F ch F7 this should change the channel > where > ch 1=$00, Ch2=$01, et > > BUT this changes channels to both edps > > if you want to change ch on only the slave you must set it to a different > device id manually (check the manual) so that the message only go to one > of > the pair > > > F0 00 01 30 0B xx 01 11 02 01 7F ch F7 > > xx is device id, id 01=$01, id 02=$02 etc.... > > but frankly you're looking for trouble when asking for complicated stuff > without really studying midi and the manual for a while > IMHO advanced stuff is for advanced users that can debug it themselves.... > > Good luck > > > Claude > > > > > > > I think if someone would walk us through putting sysex strings into the > > PMC that would be the way to do it. I looked at the sysex documentation > > in the Loop IV manual, but can't figure out how to change the channels > > via sysex. Could one of you programmers spell out the appropriate > > strings with the correct syntax so we could input this into our midi > > controllers? > > > > Thanks > > > > > > Neil > > > > > -----Original Message----- > > > From: Gary Lehmann [mailto:hqr@cox.net] > > > Sent: Tuesday, February 03, 2004 3:16 PM > > > To: Loopers-Delight@loopers-delight.com > > > Subject: How to match parameters on two EDPs > > > > > > How about sysx? That should work--'course, I haven't done it--but I > > think > > > Claude Voit wrote an editor > > > http://www.loopers-delight.com/LDarchive/200307/msg00081.html > > > That should let you do it that way. > > > Best, > > > Relay > > > >