Support |
On 23 jan 2007, at 23.09, Guy Joyce wrote: > Hi. I guess this question has been asked a million times before but > I can't find it by searching the archives. > > Q: How do you use the FCB1010 to implement 'parameter preset' > changes in the EDP ? The EDP manual says that program change > commands are required to do this. Correct. But the FCB1010 can well send MIDI program change. Over five different MIDI channels if you should need that some day. For now, just make sure you set your FCB to send the MIDI PC on the channel where the EDP is listening. > I've just gotten to grips with setting midi note numbers on the fcb > to control the usual EDP functions (thanks to a useful guide sent > by Travis Hartnett), but I'm not sure how to do program changes. > Any advice please ? It's too long to post on this list, but there's a good guide in the FCB manual. You will have to learn that anyway so why not start now? ;-)) http://www.behringer.com/_pdf/FCB1010_programming_ENG.pdf Greetings from Sweden Per Boysen www.boysen.se (Swedish) www.looproom.com (international) http://tinyurl.com/fauvm (podcast) http://www.myspace.com/looproom