Re: Echoplex LED level indicators question. Please Help Me!

[andy butler <akbutler@tiscali.co.uk>]

My EDPs are exactly the same in this respect.Actually, I'd wonder why the 
feedback LED was lighting at all during Record.
I'd ignore it, in fact I didn't even notice it happening.


Use the input LED to monitor Input.
..and the Feedback LED to tell you when you're overloading the loop.

andy butler


weeksville@comcast.net wrote:
> I am still looking for an answer to this question.  I have scoured the 
> mailing list and cannot find any help. The closest post I can find is 
> from Kim in 1998.  Please help me.  I upgraded to Loop IV 1.1 software 
> and now the input led and feedback led indicators are not working 
> properly (I think.)  The feedback led registers much hotter than the 
> input led when recording.   My echoplex is 2003 build so the input R10 
> and R 30 modification is in there.  I put the Loop III 5.0 chips back in 
> the unit and the described problem still exists.  So I put the Loop IV 
> 1.1 back in.  May main question is this... which led should I use to set 
> my levels?  I can get a good solid green signal on the feedback led 
> without the input led even registering (ie it is dark.)  When the input 
> led is good and green, no yellow/orange, and not even close to red, the 
> feedback led is orange and borders on red.  I am using the same gear I 
> have always used so my input instruments haven't changed. HELP!