Re: LP first report

["Bob Amstadt" <bobld@amstadt.com>]

It appears that after the low noise modification, the LP1 has become more 
sensitive to power line spikes which is what is causing the reboots.  I 
will 
look in to this and see if I can find a solution.  If the screen goes 
blank, 
hit the MENU button several times until it comes back.

As for the RM65B, I suspect that there is a ground loop.  Most likely it 
is 
a ground loop through the chassis.  If you were local, I could probably 
modifiy the LP1 to eliminate the ground connection through the chassis, 
but 
since you aren't, my recommendation would be to get a set of electically 
isolating mounts for the rack.  I don't remember who makes them, but I 
have 
seen them before.

I hope this helps,
Bob


----- Original Message ----- 
From: "L.Angulo" <labaloops@yahoo.com>
To: <bobld@amstadt.com>
Sent: Saturday, November 01, 2008 2:21 AM
Subject: LP first report


> Hi Bob,
> how are u? i made it safe in one piece,but after such an intensive 
>looping 
> week i am still getting back to nromality here!
> anyway,about the looperlative:
> the good news is that it has been behaving more reliable,it only locked 
>up 
> once as i was trying to set the xpression pedal on me so far, and the 
> noise and level problems are gone!
> The bad news is that when i turn my P.A. spakers on the looperlative 
> screen goes blank and i can only see the peak input nd output levels, it 
> also sometimes goes into reloading the software.
> The other is that i bought a rackmount mixer, a rolls rm65b to use it in 
> conjunctio with the LP
> http://www.rolls.com/product.php?pid=RM65b
> but when i connect the LP in its effects loop,it makes a static noise 
>and 
> the mixer becomes noisy and cannot use the LP at all.No problems however 
> when i use the LP with my soundcraft mixer.This is strange because the 
> rack mixer is new and works clean and fine with eveything else,i have no 
> idea about electronics but could it be some sort of ground problem? 
>could 
> you take a look at the rolls specs and tell me what the problem might be?
> also why do u think the screen is going blank when i turn the P.A. and 
>why 
> does it reboots? this doesnt happen with my EDP or any other equipment...
> i hope i can get this sorted out,i just want to use my LP the way 
>everbody 
> does!
> thanx and i await your response
> take care
> Luis
>
> www.myspace.com/luisangulocom
>
>
>
>