Re: desktop audio monitor stands

[Jeffrey Collins <jeffreycollins1975@gmail.com>]

Yeah I had a set for my monitor stands I built. They helped angle the speakers more correct to where I was sitting and they did reduce vibration. I would definitely buy another pair when I get a new set of monitors.

Jeffrey

On Sat, May 14, 2011 at 8:02 AM, Simeon Harris <simeonharris40@googlemail.com> wrote:

bricks with foam or rubber pads on top. 

http://www.amazon.co.uk/gp/product/B0002D0B4K/ref=pd_lpo_k2_dp_sr_1?pf_rd_p=103612307&pf_rd_s=lpo-top-stripe&pf_rd_t=201&pf_rd_i=B002CR9X2A&pf_rd_m=A3P5ROKL5A1OLE&pf_rd_r=0ANZNEWXWMSTJPN9VQE4

there's nothing special about the foam that they use for these, you could probably find some cheaper stuff somewhere and cut it to size

sim

On Sat, May 14, 2011 at 12:04 PM, Louie Angulo <louie.angulo@googlemail.com> wrote:

well that sounds good but if i dont know if house brix isloate
well,wood is a good idea.
i guess what i m looking for is brix type but made of rubber to
isolate frequencies as well and so the speakers seat stable and dont
shake at all!
cheers
Luis

On Fri, May 13, 2011 at 8:47 PM, Jeffrey Collins
<jeffreycollins1975@gmail.com> wrote:
> I recommend just going to your local home center and building them from the
> wood they have there. it'll end up way beefier and cheaper than what you
> would buy at a place like musicians friend.
>
> Cheers.
> Jeffrey
>
> On Fri, May 13, 2011 at 4:41 AM, Louie Angulo <louie.angulo@googlemail.com>
> wrote:
>>
>> hey gang,
>> Im looking for some desktop stands for my JBL studio monitors,they sit
>> too low and id like to raise them about 15 to 20 cm from the surface
>> of my desk.
>> There are a lot of monitor stands all the way form the floor but i
>> dont have much space to have them,most of those have very wide feet.
>> is there anything out there you can recomend?
>> thanx
>> Luis
>>
>>
>> --
>> www.luis-angulo.com
>>
>
>

--
www.luis-angulo.com