I think my issue is that I need them to be on separate midi channels. Basically, I need one controller to control both edps, and I don.commt think my behringer or anything else does that.
On Jun 15, 2011 9:29 AM, "andy butler" <
akbutler@tiscali.co.uk> wrote:
> Can't you just midi sync the EDPs ?
> A splitter after the Electribe?
>
> params
> SYNC = In
> 8th/Cycle = length of bar
>
> OR
>
> the edp looptimes can be shown as slightly different,
> and they'll still be in sync, as the syncing action
> chops the loop slightly.
> I'd guess actual beat length is .505 (or so)
> and the edps should stick to that.
>
>
> andy
>
> marcus kirby wrote:
>> Here's my current setup:
>>
>> Electribe midi out -> Moog MP201 Midi in -> CV Gate on/off to EDP1 and
>> EDP2 Beat Sync.
>>
>> EDP one ranges anywhere from .50 to .51 when trying to catch the beat,
>> which is fine when it's just one EDP. But when two start going together,
>> I'll have one at .51 and the other at .50, which makes EDP2 slightly off
>> sync.
>>
>> Is there a better way to sync the two?
>
