will check, thanks Daniel.
From: Daniel Thomas <danielthomas4@mac.com>
To: Loopers-Delight@loopers-delight.com
Sent: Thu, June 16, 2011 6:35:29 PM
Subject: Re: LP1 tech question
Sounds like an impedance matching problem.
Many digital mixers let you switch the impedance on Aux busses. Check your DM1000 manual. Is the AUX buss outputing +4 ? If so, can you change it?
Daniel
On Jun 16, 2011, at 9:04 AM, William Walker wrote:
> its possible that the balanced signal from your DM100 is hotter than than from your previous mixer. try turning down the send volumes feeding the looper and then use the LP-1 's master level to bring the volume back up on the back end. one question: is this an aux out designed to be an effects send or just an aux out for routing purposes?
> Bill
>
