Support |
Andy, and LD crew, Debugging: I have tried the same track-specific commands this evening, MIDI hard-wired directly into the LP-1 from an FC300 controller. Result is exactly the same: Using any of these - Assign Pedal > Track 'n' Volume / Track 'n' Feedback / Track 'n' Pan - fails to select the designated track. Let's say i am at Track 1, and have set up pedal Controllers #7 and #1 to govern Track 8 volume and feedback, respectively. Using the Track 8 Volume-assigned pedal will show in the display that it is attempting to control Vol, but the track is still Track 1, and the numeric readout is static no matter how much I flail on the pedal. Just as with the Missing Link, if I invoke the corresponding Select Track 'n' command first, then the controls work fine - for that track only of course. So I might as well be using the generic Track Volume and Track Feedback and Pan commands, with a Select Track to begin with, it would be the same thing. If I wanted the extra gesture :) So it feels to me like the track-specific Vol/Feedback/Pan commands in the LP-1 are just not working as expected. Unless there is some utterly stupid user error happening here? I am using 1.39... Any thoughts? Anyone else see this behavior? Phil :) On Aug 3, 2011, at 1:20 AM, andy butler wrote: > Strange, > it certainly works here with a regular midi controller. > I've got 24 different CC controllers handling Vol Pan and Fbk > for each track. ...and of course, to the LP-1 it makes no difference > which route > the midi came from. > > > Glad you got it working, might be worth solving the mystery though. > > It doesn't make any sense that you were able to get the LP-1 to learn > the CC values (which would have been > displayed on the front panel) and that following that it wouldn't > respond. > > Logically it's either > 1) extra commands being sent by your controller > 2) LP-1 set up file is corrupt (I doubt it, but if you can save it via > pc you could always send it to me for examination) > 3) some fault in the connection that just happened to produce the > observed result. > 4) you're using an old software version on the LP-1...I've not heard of > that issue though. > > andy > > Phil Clevenger wrote: >> Hey Andy, >> Yes, that's the perplexing thing... I am in fact using track-specific >> calls for each fader, as you suggest... I expected the behavior you >> describe, too... but the LP1 will not respond, at least not to TouchOSC >> on my iPad over wifi via the Missing Link, unless I explicitly send a >> Select Track command first :/ >> Phil :) >