RE: Minimum Requirements(EDP loopcopy)

[phillip wilson <phillwilson@hotmail.com>]

Try Next Loop > Multiply ...this copys regardless of  the loops content.

> Date: Mon, 22 Aug 2011 09:50:23 +0100
> From: akbutler@tiscali.co.uk
> To: Loopers-Delight@loopers-delight.com
> Subject: Re: Minimum Requirements(EDP loopcopy)
>
> Yep, my main technique on EDP is copying to another loop, and it
> certainly works for loops that aren't empty.
> ...and it works with the EDP's own foot controller.
>
>
> Incidentally the EDP Quantise setting does not affect the timing of 'Next',
> ...if you need it quantised then there are alternate settings of
> SwitchQuant.
>
> ..and it does get easier..just keep using it ;-)
>
>
> andy
>
>
>
> Phil Clevenger wrote:
>
> >> On Aug 21, 2011, at 10:42 PM, Mark Hamburg wrote:
> >>
> >>> I was always a bit frustrated on the EDP that you could only copy into another loop if it was empty.
> >>
> >> I've been copying into non-empty loops by setting Quantize = Loop or Cycle, and SwitchQuant = CNF. Then I can press NextLoop, and at my leisure press Multiply. Then regardless of the next loop's content, at the next quantized point it starts to lay in the current loop's cycles until you tell it to stop.
> >>
> >> I'd like that to be easier - as you would too I imagine :D But it works :)
> >>
> >> Phil :)
> >
> >
>