Re: EDP Powering problem.

[eib halimski <halimzainal@gmail.com>]

my bad. sorry for the slight misinformation. thank you for correcting.

thats not the problem

if one was only 130V it would theoretically be possible to create a short circuit when loaded with 230V but very unlikely

the current through the EDP is far below 2A anyway, so if there was a fault in it, the internal fuse would blow, exept if there is a short cirquit right at its power socket.

the safety switch reacts to much smaller currents that "run away" so if only this switches off, there may be a insulation problem in the EDP, maybe even a cap between power input and ground which is too big for your safety switch.

first test would be whether the power cable itself makes the fuse blow