Re: airFX level mismatch.

[andy butler <akbutler@tiscali.co.uk>]

RP Collier wrote:

> The signal going in to the AirFx needs to be -10. If the EDP has a 
> switch to change output to -10 then that works. Otherwise you need 
> something to change the level to line level, like a DI or line level 
> shifter.

Or the Output Level control on the EDP.

Assuming that the issue here is that the AirFX runs 
at -10dB then all you have to do is 
reduce the level from the EDP 'till
the Air FX behaves.



...but from your original post I'm not sure that solves the problem.

Are you saying some patches are much louder than others?

In any case "line Level" hasn't meant -10dB since they did away
with using 5 pin din connectors (in the mid 70's ?).

It's a mystery why some manufacturers use it today, probably 
connected to "cheap gear" :-(

andy