Re: Halfspeed doesn't work with Mobius and Softstep

[Jeff Larson <jeff.larson@sailpoint.com>]

Make sure you are using the function named "Speed" and not "Halfspeed".

Speed is the function that toggles half speed on and off.  Halfspeed is
the function that puts you in half speed if you're not already there, but
leaves you there if you're already in half speed.  It is the opposite of
"Fullspeed".

The names are changing in the next release to be "Toggle Halfspeed" and
"Halfspeed".

As far as the SoftStep weirdness I can't be much help other than checking
to make sure it isn't sending out anything extra besides the one note you
want for Speed.  If it sending out extra stuff, Ableton might be trying to
respond to it.

Jeff


On 7/5/12 6:09 PM, "Christoph Lehmann" <krrrs@gmx.de> wrote:

>Hello everyone,
>
>I'm exploring Mobius since a while and I recently switched from the
>fcb-1010 controller to a keith mcmillen softstep, due to its size and
>cause it's usb powered.
>
>In addition to the fact this pedal is very wayward, it seems like it
>can't control the half speed function properly.
>I can switch a loop to half speed, but once it is in the half speed mode,
>i can't go back to normal speed with a second press. instead there
>appears noise with each further press and sometimes it causes ableton,
>which i use as host, to crash. I don't have this problem with any other
>function and never had it before, when i used the fcb.
>any ideas?
>
>Sorry for my bad grammar ;)
>Chris
>