Re: Newbie EDP Question

[mark francombe <mark@markfrancombe.com>]

Sounds a little like a hardware problem... Im afraid... maybe a unit reset would help? 
(hold down parameter button while you boot up)

Also I think there maybe be a trimpot to adjust feedback, but that might be a myth...

Mark

On Mon, Aug 13, 2012 at 10:26 PM, Philipp Zürcher <philipp.zuercher@mem.li> wrote:

- what software are you running? LoopIV or earlier?
- is there anything plugged into the Feedback socket on the rear of your EDP?
-  you sure you are in Loop Mode and not Stutter, Flip, or Expert?

best

Philipp

Am 13.08.2012 um 22:10 schrieb Jeff Shirkey:

>
> On Aug 13, 2012, at 2:49 AM, Philipp Zürcher wrote:
>
>> Press: Parameter, then Record (Loop/Delay) and choose "LOP" for Loop instead of "dEL" for Delay.
>
> Unfortunately, that didn't do the trick. It was already in LOP mode, so something else is going on.
>
> I'll start reading the manual, but if anyone else has any suggestions, I'd appreciate it.
>
> Thanks,
>
> Jeff
>
>

-- 
Mark Francombe

www.markfrancombe.com
www.ordoabkhao.com

http://vimeo.com/user825094
http://www.looop.no

twitter @markfrancombe
http://www.flickr.com/photos/24478662@N00/