Re: Is it possible to sync Vortex to EDP?

[Matthias Grob <matthias@grob.org>]

>Matthias Grob wrote:
>
>>  Make a cable with any diode in series and a 2 MF cap to ground:
>>
>>                   |   |
>>                   |  /|
>  >              -   | / |  +
>  > EDP   ----------|/  |---------------------  VORTEX
>>                   |\  |        |
>>                   | \ |        |
>>                   |  \|        |    +
>>                   |   |     -------
>>                           -----------
>>                                |
>  >                               |          -
>  >                               |
>>                                | /
>>                                |/
>>                                /
>>                               /
>>
>>  The parts fit into an ordinary 1/4" connector.
>
>sorry Mathias
>
>I can solder but thats all...
>
>can you comment on the parts (cap type ; microF or miliF and where are
>the + & -  on the diagram

no problem:
MiliFarad is not used, and would be m, so MF is microFarad.
To fit into the connector, it take its an electrolytic. Thats why (by 
some standard) one line is longer than the other - the negative pole, 
going to ground.
Its voltage can be as low as 6,3V, but higher is ok, just makes the 
part bigger.
There are also Tantal caps of this size. I dont use them because I 
made the experience that they die sooner, but I may be wrong, its an 
interesting option since you may not use that cable more than 5 years 
:-).

The diode is a standard like 1N4148 and on one side of its glass 
housing there is a line which corresponds to the negative side, the 
line in its symbol, on the left in the drawing.

>this mod looks great

yes, I liked the idea, too. Could go into the FAQs or so... Kim?


          ---> http://Matthias.Grob.org