] [Thread Prev
Re: Dual EDP (was Re: Delaying MUTE action?)
At 09:11 PM 12/3/98 -0000, Gerry P wrote:
>Thanks for the quick response. The MuteMode=continuous didn't solve my
>problem completely - in that I still can't get the action of a MUTE press
>delay to the end of the cycle ( which I had previously) - not immediate -
>which the manual indicates is the only way.
please check my reply again, looks like you missed the first half of the
sentence: "turn quantize parameter on."
>I also have a another question
>I use my EDP along with my DAT in my home studio. I would love to have
>setup in stereo.
>Could I sync the two machines (special cable??), controlling each with
>separate foot switches? Is the EDP foot controller of any benefit in
>controlling two EDP's.
>( vs two EV5's for each)
>For my needs, two EV5 foot switches are all I need for my one EDP.
check out the echoplex FAQ on the Looper's Delight page. There is an entire
section on stereo echoplexes:
if you still have some question after that, let us know.
>Thanks in advance
>From: Kim Flint <firstname.lastname@example.org>
>To: Loopers-Delight@annihilist.com <Loopers-Delight@annihilist.com>
>Date: Thursday, December 03, 1998 4:08 AM
>Subject: Re: Delaying MUTE action?
>>turn quantize parameter on, MuteMode=continuous.
>>At 09:15 PM 12/2/98 -0000, you wrote:
>>>I had my EDP set up so that when I hit MUTE, the loop would continue
>>>until the end of the current cycle and then mute - and hitting UNDO,
>>>the loop from the start - immediately.
>>>Last night I was playing with some EDP settings and now I can't get back
>>>the above. Not only that, but the manual says that MUTE always acts
>>>Any suggestions would be appreciated.
>>Kim Flint, MTS 408-752-9284
>>ATI Research email@example.com
Kim Flint, MTS 408-752-9284
ATI Research firstname.lastname@example.org