Re: Vortex problem

[Todd Pafford <galen@erols.com>]

The problem is a faulty rotary encoder.  Mine did this a few years back 
except 
it seemed a little worse than the symptoms you're describing.  Lexicon was 
very helpful in getting it fixed.  I had to pay their repair charge (I 
think 
it was $49 at the time), but they fixed it right up.

Call Lexicon's Consumer Support at (781) 280-0300 or email them via the 
following website:
http://www.lexicon.com/support/legacysupport.asp

Good luck,
Todd Pafford


On Mon, 13 Aug 2001, erdem helvacioglu wrote:

> My Lexicon Vortex switches between presets automatically. Like say I 
>load 
> 5A, after sometime it loads 8A, then switches between these presets.(10 
> times in a minute)