Re: loop IV test modes?

[Bret <echoplex@yahoo.com>]

Thanks Kim
--- Kim Flint <kflint@loopers-delight.com> wrote:
> At 04:48 PM 9/9/2002, Bret wrote:
> >Kim, Matthias, et. al.
> >
> >Recently, I needed to run the VCA DC offset trimmer test.
> >I followed the archives listing:
> >To get into the trimmer test, Start the unit while holding the
> >Parameter and Record buttons down. Keep them held while the startup
> >screen goes by, until the display shows all t's. Then let go. Should
> >say 7F. Press parameter so the "Keys" LED is lit, then press Insert
> to
> >start the trimmer test.
> >
> >This does not work as described, in Loop IV, so I put Loop III in
> the
> >edp and ran the test and set the trim pot.  It worked fine.
> >
> >Is there a way to enter test modes in Loop IV?
> 
> hold down Parameter and Overdub at power up to get to that set of
> tests in 
> LoopIV. you don't have to wait for the startup screen to finish
> anymore, it 
> goes directly to the test.
> 
> >Are there other test modes that may be useful in Loop IV?
> 
> go to the midi row, press mute, turn feedback knob.
> 
> kim
> 
> 
>
______________________________________________________________________
> Kim Flint                     | Looper's Delight
> kflint@loopers-delight.com    | http://www.loopers-delight.com
> 


__________________________________________________
Yahoo! - We Remember
9-11: A tribute to the more than 3,000 lives lost
http://dir.remember.yahoo.com/tribute