Re: Repeater for Sale

[Per Boysen <perboysen@gmail.com>]

I think you are asking for trouble since you are asking if you are
asking for trouble. To not get into trouble you would need to
understand, and act according to, that each MIDI device has to be set
to listen to the MIDI channel you are sending its control data through
by the FCB1010 pedalboard. If sticking to that knowledge you simply
have to connect stuff for appropriate signal paths and set the needed
conditions. If you are not used to do things systematically a good
trick is to follow the signal path - both in audio streaming and
control data.

Sorry, but I don't know what to answer a question like "is it easy to....".

Greetings from Sweden

Per Boysen
www.boysen.se
www.perboysen.com



On Fri, Feb 5, 2010 at 9:19 PM, Todd Matthews <gtmatthews@gmail.com> wrote:
> Per,
> you just replied to Chris in the Rang III thread that it would be easy to
> use Mainstage for just effects and then the Rang for looping....  Would 
>it
> be easy, using the laptop just for effects, to change my effect patches 
>in
> Mainstage with the FCB and also use the same FCB to control the Repeater?
> ....or would I be asking for trouble?
> Todd Matthews
>
> On Fri, Feb 5, 2010 at 11:03 AM, Per Boysen <perboysen@gmail.com> wrote:
>>
>> On Fri, Feb 5, 2010 at 5:00 PM,  <eddrake1@comcast.net> wrote:
>> > Yes the Repeater is MIDI controllable so an FCB1010 should be ok. I
>> > don't
>> > own an FCB but I recall other folks using them.
>>
>> I used a Repeater for a couple of years and controlled it by an
>> FCB1010. Worked like a charm! You program the pedal board to send the
>> MIDI events hardwired to certain functions in the Repeater.
>>
>> Greetings from Sweden
>>
>> Per Boysen
>> www.boysen.se
>> www.perboysen.com
>>
>
>