|
The problem happens only when I connect my foot pedals to akai apc40,
if I connect to my korg midi keyboard it works fine... but I only have
one connection for that. I think it must have something to do with the
polarity. I am thinking about getting a behringer fcb but I just dont
want the hassle of programming it right now... and I really cant afford
it either... at this point I think I might prefer playing with other
human beings... looking over previous mails... I must have missed Ricks mail. It was really very informative. I am thinking how I can go about replacing a loop in Ableton. I suppose I have to assign many controls to one midi switch with Midi Translator. Am 3/9/10 5:12 PM, schrieb Rafael Nunes: 4cdf3b971003090812k58519ba6p8d4458dd3e1892fa@mail.gmail.com" type="cite">I also found that my axiom49 was programmed to send an on/off message everytime I pressed the sustain pedal. Whichever MIDI controller you're using, make sure that you're setting your footswitch correctly in the software editor. Also sometimes footwswitches have a polarity switch that reverses their functioning. I had similar problems with looper and in my case it turned out to be software related, but those two are the main reasons you'd running into that problem. You'll figure it out though, I literally almost broke my Axiom for a couple of days beore figuring it out!! Again, if you want some song based looping ideas, I do exactly that with covers and originals, as well as jams(which i still try to give the air of composition, or at least group improv, rather than loop based music): -- Nadia Salom http://www.nirmala07.net http://www.ubetoo.com/nirmala07 |