On Mar 12, 2011, at 7:29 AM, "andy butler" <
akbutler@tiscali.co.uk> wrote:
> mark francombe wrote:
>> Currently a Behringer Eurorack Pro 1U 16 input, 1 aux, mute buttons, pan.
>
>> Absolute necessities MUST BE (dont post if these are not available)
>> 1) 1U 2) 8 STEREO channels (16 mono is also ok, but annoying..)
>> 3) 1 AUX SEND
>
> Alesis Multimix Line 8
> (it's not hissy)
> ...and it's mod-able,
> the circuit schematic is available.
>
>
>> 1)Some other way to send signal to my loopers. Currently I'm wasting the send on that.
>> I could do with either an EXTRA send but i dont really like that, because I dont NEED to set a level everytime I want to loop... I want to do that on the looper, I just want to route the signal, via a switch.
>
> I could look at the Alesis schematic and see if that's possible.
> ...but it would need holes drilling in some tough metal,
> and (i expect) some additional resistors.
>
>> The Behringer has a MUTE switch, and Ive often thought about if I could take a signal from THAT bus to the loopers, so instead of muting it routed.
>
> while on some mixers the Mute goes to a Bus, that's not the
> case here.
> Likely those switches are just single pole single throw
> (just on/off)...it might be possible to re-purpose them
> as sends, but I think you'd need some additional circuitry.
>
> Without a schematic, modding isn't at all easy.
>
> My pre-schematic attempt to mod the Alesis was a disaster.
>
>> 2)Some kind of insert: just on the main outs would be ok (I neens to put my WHOLE rig thru one stereo effect. (I can achieve this just by putting the mixer before this effect so its not a biggie)
>
> another possible Alesis mod would do this (but would use
> up the circuit you wanted for the aux send)
>
>> 3)A really basic EQ.
>
> no ideas
>
> andy
>
